- Joined: 17 Mar 2021
- Posts: 3
|
Game Gear Fully Recapped Mcwill Screen Black not turning on
Posted: Wed Mar 17, 2021 9:52 pm
|
Hi
I had a game gear to repair,it didn't power on at all but I did a full recap on it and now powers on, has sound but the screen was completely
I had a mcwill screen so I thought I'd fit that instead. After following the guide step by step I finished the mod but unfortunately screen still doesn't come on just black screen
I've checked all connections multiple times, checked voltage and continuity all looks fine
I've gone over it so many times now that it's all getting messy, I have other units to fit it to but just want to be sure I haven't made a mistake before I start on a new console
Please excuse some of the horrible sloppy soldering, I spent hours messing with it but I've checked all connections and are good
|
- Joined: 17 Mar 2021
- Posts: 3
|
Posted: Sat Mar 20, 2021 3:10 am
|
Ok I've completely rewired it with kynar wire, much cleaner and I also decided to use the correct instructions this time......don't......
It's now turning on so improvement, but there is distorted lines and colours are missing
Checked all connections looked fine but reflowed, all fine
Adjusted screen ribbon cable but still the same
Any ideas?
|
- Joined: 17 Mar 2021
- Posts: 3
|
Posted: Sat Mar 20, 2021 12:15 pm
|
Should anyone have the same problem here's how I resolved it.
The issues was with the 6 wires connecting to the edge of the board where the old LCD connected
I scratched the surface of the vias above the 6 connecting pins and bridged the wires to them, problem solved
|