Author |
Message |
- Joined: 17 Nov 2013
- Posts: 19
- Location: Denmark
|
Mark III 3D Glasses and Everdrive.
Posted: Wed Mar 02, 2016 11:22 pm
|
I have a Mark III and the 3D Glasses and it works with the normal 3D games no problem, but its like the Everdrive doesnt activate the glasses i wonder if its the Adapter or the everdrive.? Anyone have an aweser would be wery much apriciated.
|
|
|
- Joined: 25 Feb 2013
- Posts: 384
- Location: Osaka
|
Posted: Fri Mar 04, 2016 11:53 am
|
3d games should not connect !card to vcc. if i remember correctly they are pins B1 and b2.check if the adapter is shorting those 2 pins. if it does just disconnect b2 by cutting the trace.
|
|
|
- Joined: 17 Nov 2013
- Posts: 19
- Location: Denmark
|
Posted: Sat Mar 05, 2016 6:58 am
|
Thanks ill look in to that. :)
|
|
|
- Joined: 17 Nov 2013
- Posts: 19
- Location: Denmark
|
Posted: Sat Mar 05, 2016 7:10 am
|
I have this adaptor how dies i find the pin. And does it work on this adaptor?
|
|
|
- Joined: 17 Nov 2013
- Posts: 19
- Location: Denmark
|
Posted: Sat Mar 05, 2016 7:14 am
|
The front
|
|
|
- Joined: 25 Feb 2013
- Posts: 384
- Location: Osaka
|
Posted: Sun Mar 06, 2016 10:49 pm
|
the front pic is very blurred and I cannot see much. the 2 pins on the right are bridged. that is fine. how about the leftmost 2 pins? i cannnot see
|
|
|
- Joined: 17 Nov 2013
- Posts: 19
- Location: Denmark
|
Posted: Mon Mar 07, 2016 6:04 am
|
It worked thank you so much :)
|
|
|
- Joined: 14 Apr 2021
- Posts: 1
|
Posted: Wed Apr 14, 2021 11:44 pm
|
kamillebidan wrote the front pic is very blurred and I cannot see much. the 2 pins on the right are bridged. that is fine. how about the leftmost 2 pins? i cannnot see
Very instresting thread ! I own the aliexpress adapter. someone know how to cut the bridge between B1 and B2 ?
On the area of B1 and B2, the traces is very difficult to identify / track.
EDIT : IT WORK, MANY THANKS !!!
Easy, without any damage for the adapter : I juste put a little piece of tape one the pin B2 (adapter front of you, the second pin from left).
Adapter and everdrive plugged on the mark 3, AND ALL 3D GAMES WORKS, thanks again to @kamillebidan !
|
|
|
- Joined: 13 Mar 2024
- Posts: 1
|
Posted: Wed Mar 13, 2024 2:31 pm
|
Thanks i´ve learned with my recent bought mark 3 the following:
- You need to change capacitor C18 with 1uf to make Everdrive works with adapter.
- You need to block pin number B2 (just put a small transparent stick on it in the adapter)
- You need to use RGV cable from france or make a RGB amp to see the games correctly.
Many thanks!
|
|
|