aresius wrote
Hello everyone, I did a McWill mod on a GG (1 asic). GG has been fully recapped (power board, audio, and the mainboard). I installed a McWill screen as the original screen was cracked (wanted to upgrade anyway)
The result is black screen, nothing happens. The screen turns on but stays black after an initial flash. The led works, the backlight of the screen is on. Anything else that I might have missed (or anything else that might be broken on the gg)?
Hi. It looks like you have wires attached to the contrast potentiometer, but this is not needed unless you are also installing the VGA out part of the mod.
The text from where it says "Solder pin 1 of the thumbwheel to VCC on the GG board" down to the section on buttons can be ignored.
Try removing all the wires to and from the contrast wheel and see how you go.