Sega Master System / Mark III / Game Gear
Having cut the Veroboard to size, we're now ready to start the building process. We begin with the power supply section, which provides a stable 5 volt supply to the ICs and to the cartridge.
The holes are referenced by their hole number and track letter(s), as explained in the previous section. Use the template you drew to find the appropriate hole.
Solder in the following components:
Ensure the capacitor is flush with the board. Note that it's very important that you get the terminals the right way round - electrolytic capacitors have a habit of exploding rather nastily when their polarity is reversed, which could cause you serious harm if you're anywhere in the vicinity.
Connect between 13B and 13D.
Bend the pins of the regulator and solder them into the following holes:
The regulator should be mounted vertically (i.e. perpendicular) and as close to the board as possible.
As with the electrolytic capacitor, make sure you get the terminals the right way round.
Now, as described in the previous section, we must cut some tracks to break circuit connections. Take your track cutter and drill the following holes:
All being well, your board should now look something like this: